Bedding In Procedure

Please follow the recommended bedding-in procedure for best result of braking performance.

1. After fitting new Disc brake pads, accelerating velocity to 60 km/h.
2. Push brakes using to moderate pedal effort to reduce speed to approximately 10 km/h.
3. Repeat step 1 and 2 approximately 10 times, to condition material surface of rotor and Disc brake pads.
4. After bedding-in can be drive at normal condition.
5. Avoid hard braking for first 100 km
   
   

If do not follow-up bedding-in procedure, there will be problems asthe following.

1. Excessive heat will be generated on the surface of Disc pads.
2. Resin will burn, noise and dust.
3. Loss of good braking performance.
4. Can experience fade (slippery).